As a subsidiary of CPEG, additional thermal and dry solids processing and material handling equipment is available to supplement and build out your production line.

Calciners, Conveyors, Vibratory Fluid Beds, Baghouses, and more.

6SC12 Split Tube Conveyors

  • 6″ diameter screw x 12′ long with 2/3 pitch inlet flighting, balance full pitch flighting
  • 2-1/4 ft3 hopper with bolted safety grating
  • 6″ standard pipe stub discharge
  • 3 HP, 1800 RPM 3/60/230-460V TEFC (4:1) inverter duty motor
  • 10:1 gear reducer for final auger speed of approx. 175 RPM
  • Standard cleanout with 120 VAC limit switch (mounted not wired)
  • Many different hoppers available for the rental units
  • Controls, wiring and installation by customer
split tube conveyor

Construction Details

  • 304 Stainless steel construction in product contact areas
  • Interior surfaces uniform 80 grit finish
  • Exterior surfaces uniform Scotch-Brite finish
  • Continuous weld on both sides of flighting
  • Welds in contact with product continuous and ground to 80 grit finish
  • Welds not in contact with product intermittent and ground smooth, gaps filled with Devcon
  • Covers on trough are gasketed, hinged and fastened into place with plastic hand knobs, with 120 VAC limit switch (mounted not wired)
  • Mild steel portable base with two (2) rigid and two (2) swivel casters with brakes and hydraulic jack for angle adjustment
  • Rotating mechanical shaft seal on the drive and single lip seal on discharge end
  • Exterior mild steel components (motor, bearings, etc.) to be one coat primer and one coat white epoxy
installation drawing

To rent a stock item call 716.934.2611 or fill out and submit the form below.