6U8-JS Heating / Cooling Conveyor
Available : 1
Features
- Trough to have formed for cover mating surfaces
- Drive and discharge end plates to be welded
- Covers on trough:
- Gasketed (with temperature appropriate material)
- Integral jacket for insulation
- Hinged (with integral stop) and fastened into place with
- DeStaco clamps (inlet cover to be removable)
- Overlapping covers require discharge cover to be opened first
- Two (2) couplings for process chamber purge
- 120 VAC Limit switch mounted (not wired)
- 6″ OD Plain tube inlet
- 6″ OD Plain tube discharge
- Saddle supports along conveyor for mounting to supplied structure Optional Design Features Included
- Oversized shaft pipe with flanged journals
- Journals thru-bored and equipped with single flow unions to allow cooling fluid flow through shaft
- Integral jacket for cooling fluid
- Inlet, outlet and drain couplings
- Constructed of 304 stainless steel
- Internal flow baffles
- Designed for low pressure, 14.9 psig max. (non-ASME coded jacket)
- Integral jacket for insulation Standard Components
- 2 HP, TEFC, 1750 RPM, 3/60/230-460 motor
- Foot mounted gear reducer for a nominal speed of 20 RPM
- Primary shaft, chain and sprocket connection for thermal break
- Chain and shaft guards Optional Components Included
- Split packing gland seals with temperature appropriate packing and set up with air purge
- Flange block bearings for auger support
- Portable base with instrumentation
Augers
- 1/2 Pitch, 1/4″ thick right hand flighting constructed of 304 SS
- Shafting constructed of 3″ schedule 40 pipe Finish Details
- Product contact surfaces to be 2B mill finish
- Exterior stainless steel surfaces to be mill finish
- Interior welds to be continuous and ground smooth and flush to 80 grit, no pits, cracks, or crevices allowed
- Jacket welds are continuous and ground smooth
- Exterior, non-jacket welds are intermittent, wire brushed and gaps sealed with Devcon
- All carbon steel components to be painted with one primer coat and one top coat (S. Howes standard blue) Standard Design
Construction Details
- 304 Stainless steel in product contact areas
- U-Trough style housing, 8 feet long inside
- Trough form constructed of 7 gauge 304 SS
- End plates constructed of 5/16″ thick 304 SS
- Covers constructed of 10 gauge 304 SS